Whirlpool & Maytag · Dryer
F1
Control board error
What causes it
Main control board fault.
What it means in practice
The dryer's main control board reported an internal error. It can sometimes be cleared with a power reset, but a repeat code points to the board.
What to check before calling
- ✓Power-cycle the dryer at the breaker for 1 minute.
- ✓If it returns right away, the control board likely needs service.
- ✓Unplug the dryer for five minutes, then plug it back in and try again.
- ✓Check the plug and outlet for damage.
When to call a technician
If F1 returns after a reset, the control board needs testing.
If those checks don't clear the F1 code, it's usually a sign of a failed part rather than something to keep resetting. A technician runs a full diagnostic on your dryer, confirms the cause, and quotes the repair before any work starts. The $89 service call is waived if you go ahead with the repair, and parts and labor are covered by our 90-day warranty on parts & labor.
Common question
Do I need a new control board?
Not always. A connection or sensor can cause a similar code, so we diagnose before recommending a board.
Still showing F1?
Same-day diagnosis and repair across Las Vegas, Henderson, and Summerlin. $89 service call, waived with repair.
Other Dryer Error Codes
Not seeing F1, or want to compare it against a different code on the display? Here's what these other common dryer codes mean.