Whirlpool & Maytag · Washer
F7 E1
Motor drive error
What causes it
Motor control board or wiring fault.
What it means in practice
The washer's control can't communicate properly with the drive motor. That points to the motor control board or a loose connection, not something you can see from outside.
What to check before calling
- ✓Power-cycle the washer at the breaker.
- ✓If the code returns immediately, avoid running further cycles — this usually needs a technician.
- ✓Unplug the washer for several minutes and try again to rule out a temporary glitch.
- ✓Make sure the washer isn't overloaded, since a jammed drum can look like a motor fault.
When to call a technician
If F7 E1 returns, the motor control board or wiring needs testing.
If those checks don't clear the F7 E1 code, it's usually a sign of a failed part rather than something to keep resetting. A technician runs a full diagnostic on your washer, confirms the cause, and quotes the repair before any work starts. The $89 service call is waived if you go ahead with the repair, and parts and labor are covered by our 90-day warranty on parts & labor.
Common question
Is F7 E1 an expensive repair?
It depends on whether it is a wire connection or the board itself. We test first so you only pay for what has actually failed.
Still showing F7 E1?
Same-day diagnosis and repair across Las Vegas, Henderson, and Summerlin. $89 service call, waived with repair.
Other Washer Error Codes
Not seeing F7 E1, or want to compare it against a different code on the display? Here's what these other common washer codes mean.